D-Link X-STACK DES-3200 SERIES - Page 149

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
145
Example
To configure the Switch’s configuration file as boot up:
DES-3200-28P:admin#config configuration config.cfg boot_up
Command: config configuration config.cfg boot_up
Success.
DES-3200-28P:admin#
15-3 save
Description
This command is used to save the current configuration to a file.
Format
save {[config <pathname 64> | log | all]}
Parameters
config - (Optional) Specify to save the configuration to a file.
<pathname64> - The pathname specifies the absolute pathname on the device file system. If
pathname is not specified, it refers to the boot up configuration file.
log - (Optional) Specify to save the log.
all - (Optional) Specify to save the configuration and the log.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To save the configuration:
DES-3200-28P:admin#save config c:/3200.cfg
Command: save config c:/3200.cfg
Saving all configurations to NV-RAM.......... Done.
DES-3200-28P:admin#
15-4 show boot file
Description
This command is used to display the configuration file and firmware image assigned as boot up
files.
Format
show boot_file