D-Link X-STACK DES-3200 SERIES - Page 191

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
187
Restrictions
Only Administrator-level users can issue this command.
Example
To set the Switch to not need a reboot when a fatal error occurs:
DES-3200-28P:admin#debug config error_reboot disable
Command: debug config error_reboot disable
Success.
DES-3200-28P:admin#
18-5 debug config state
Description
This command is used to set the state of the debug.
Format
debug config state [enable | disable]
Parameters
enable - Enable the debug state.
disable - Disable the debug state.
Restrictions
Only Administrator-level users can issue this command.
Example
To set the debug state to disabled:
DES-3200-28P:admin#debug config state disable
Command: debug config state disable
Success.
DES-3200-28P:admin#
18-6 debug show error_reboot state
Description
This command is used to display debug error reboot state.