D-Link X-STACK DES-3200 SERIES - Page 192

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
188
Format
debug show error_reboot state
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To show the debug error reboot state:
DES-3200-28P:admin#debug show error_reboot state
Command: debug show error_reboot state
Error Reboot: Enabled
DES-3200-28P:admin#
18-7 debug show status
Description
This command is used to display the debug heanler state and the specified module’s debug status.
Format
debug show status {module <module_list>}
Parameters
module – (Optional) Specify the module list.
<module_list> - Enter the module list.
Restrictions
Only Administrator-level users can issue this command.
Example
To show the specified module’s debug state: