D-Link X-STACK DES-3200 SERIES - Page 23

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
19
Format
show terminal width
Parameters
None.
Restrictions
None.
Example
To display the configuration of current terminal width:
DES-3200-28P:admin#show terminal width
Command: show terminal width
Global terminal width : 80
Current terminal width : 80
DES-3200-28P:admin#
2-17 config ports
Description
This commands is used to configure the Switch's port settings.
Format
config ports [<portlist> | all ] {medium_type [fiber | copper]} {speed [auto | 10_half | 10_full |
100_half | 100_full | 1000_full {[master | slave]} ] | flow_control [enable | disable] | learning
[enable | disable ] | state [enable | disable] | mdix [auto | normal | cross] | [description <desc
1-32> | clear_description]}
Parameters
<portlist> - Enter a list of ports used here.
all - Specify that all the ports will be used for this configuration.
medium_type - (Optional) Specify the medium type while the configure ports are combo ports
fiber - Specify that the medium type will be set to fiber.
copper - Specify that the medium type will be set to copper.
speed - (Optional) Specify the port speed of the specified ports .
auto - Set port speed to auto negotiation.
10_half - Set port speed to 10_half.
10_full - Set port speed to 10_full.
100_half - Set port speed to 100_half.
100_full - Set port speed to 100_full._
1000_full - 1000_full set port speed to 1000_full. While set port speed to 1000_full,user
should specify master or slave mode for 1000 base TX interface, and leave the 1000_full