D-Link X-STACK DES-3200 SERIES - Page 24

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
20
without any master or slave setting for other interface.
master - Specify that the port(s) will be set to master.
slave - Specify that the port(s) will be set to slave.
flow_control - (Optional) You can turn on or turn off flow control on one or more ports. By set
flow_control to enable or disable.
enable - Specify that the flow control option will be enabled.
disable - Specify that the flow control option will be disabled.
learning - (Optional) You can turn on or turn off MAC address learning on one or more ports.
enable - Specify that the learning option will be enabled.
disable - Specify that the learning option will be disabled.
state - (Optional) Enables or disables the specified port. If the specificed ports are in error-
disabled status , configure their state to enable will recover these ports from disabled to
enable state.
enable - Specify that the port state will be enabled.
disable - Specify that the port state will be disabled.
mdix - (Optional) MDIX mode can be specified as auto, normal, and cross. If set to normal state,
the port is in MDIX mode and can be connected to PC NIC using a straight cale. If set to cross
state, the port is in mdi mode, and can be connected to a port (in mdix mode) on another
switch thru a straight cabe.
auto - Specify that the MDIX mode for the port will be set to auto.
normal - Specify that the MDIX mode for the port will be set to normal.
cross - Specify that the MDIX mode for the port will be set to cross.
description - (Optional) Specify the description of the port interface.
<desc 1-32> - Enter the port interface description here. This value can be up to 32 characters
long.
clear_description - (Optional) Specify that the description field will be cleared.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the ports:
DES-3200-28P:admin#config ports all medium_type copper speed auto
Command: config ports all medium_type copper speed auto
Success.
DES-3200-28P:admin#
2-18 show ports
Description
This command is used to display the current configurations of a range of ports.
Format
show ports {<portlist>} {[description | err_disabled | details | media_type]}
Parameters
ports - Specify a range of ports to be displayed.