D-Link X-STACK DES-3200 SERIES - Page 257

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
253
Format
dir {<drive_id>} {<pathname>}
Parameters
<drive_id> - (Optional) Enter the drive ID used, for example, C:.
<pathname> - (Optional) Specify the directory to be removed. The path name can be specified
either as a full path name or partial name. For partial path name, it indicates the file is in the
current directory.
Restrictions
None.
Example
List the files:
DES-3200-28P:admin#dir
Command: dir
Directory of /c:
Idx Info Attr Size Update Time Name
--- ------- ---- -------- ------------------- ----------------
1 RUN(*) -rw- 5491536 2000/01/01 00:41:03 DES3200_RUNTIME_V4.00.014.had
2 CFG(*) -rw- 31142 2000/01/01 02:19:40 config.cfg
3 d--- 2000/01/01 00:00:16 system
29618 KB total (24127 KB free)
(*) -with boot up info (b) -with backup info
DES-3200-28P:admin#
28-6 rename
Description
This command is used to rename a file. Note that for standalone device, the unit argument is not
needed. This command is used to rename a file in the file system. The pathname specifies the file
(in path form) to be renamed and the filename specifies the new filename. If the pathname is not a
full path, then it refers to a path under the current directory for the drive. The renamed file will stay
in the same directory.
Format
rename {<drive_id>} <pathname> <filename>