D-Link X-STACK DES-3200 SERIES - Page 258

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
254
Parameters
<drive_id> - (Optional) Enter the drive ID used, for example, C:.
<pathname> - Specify the file (in path form) to be renamed.
<filename> - Specify the new name of the file.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To rename a file:
DES-3200-28P:admin#rename run.had run1.had
Command: rename run.had run1.had
Success.
DES-3200-28P:admin#
28-7 del
Description
This command is used to delete a file, either physically or softly. It is also used to delete a directory
and its contents. If two files with the same name under the same directory are softly deleted
sequentially, only the last one will exist. Deleting, copying, renaming or moving the already softly
deleted file is not acceptable.
System will prompt if the target file is a FW or configuration whose type is bootup.
Format
del {<drive_id>} <pathname> {recursive}
Parameters
<drive_id> - (Optional) Enter the drive ID used, for example, C:.
<pathname>- Specify the file or directory to be deleted. If it is specified in the associated form,
then it is related to the current directory.
recursive - (Optional) Used on directory, to delete a directory and its contents even if it’s not
empty.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
Delete a directory with parameter “recursive”: