D-Link X-STACK DES-3200 SERIES - Page 324

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
320
<port> - Enter the port number used here.
Restrictions
None.
Example
To display the DHCP snooping binding entries:
DES-3200-28P:admin#show address_binding dhcp_snoop binding_entry
Command: show address_binding dhcp_snoop binding_entry
S (Status) - A: Active, I: Inactive
Time - Left Time (sec)
IP Address MAC Address S Time Port
--------------------------------------- --------------------- -- ----- ------
10.62.58.35 00-0B-5D-05-34-0B A 35964 1
10.33.53.82 00-20-c3-56-b2-ef I 2590 2
Total entries : 2
DES-3200-28P:admin#
31-14 config address_binding dhcp_snoop max_entry
Description
This command is used to specify the maximum number of entries that can be learned by a
specified port.
Format
config address_binding dhcp_snoop max_entry ports [<portlist> | all] limit [<value 1-50> |
no_limit]
Parameters
ports - Specify the list of ports you would like to set the maximum number of entries that can be
learned.
<portlist> - Enter the list of ports used here.
all - Specify that all the ports will be used.
limit - Specify the maximum number. The default value is no_limit.
<value 1-50> - Enter the limit value here. This value must be between 1 and 50.
no_limit - Specify that the maximum number of learned entries is unlimited.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.