D-Link X-STACK DES-3200 SERIES - Page 327

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
323
31-18 debug address_binding
Description
This command is used to start the IMPB debug when the IMPB module receives an ARP/IP packet
or a DHCP packet.
Format
debug address_binding [event | dhcp | all] state [enable | disable]
Parameters
event - To print out the debug messages when IMPB module receives ARP/IP packets.
dhcp - To print out the debug messages when the IMPB module receives the DHCP packets.
all - Print out all debug messages.
state - This parameter configures the IMPB debug state to be enabled or disabled.
enable - Specify that the state will be enabled.
disable - Specify that the state will be disabled.
Restrictions
Only Administrator users can issue this command.
Example
To print out all debug IMPB messages:
DES-3200-28P:admin#debug address_binding all state enable
Command: debug address_binding all state enable
Success.
DES-3200-28P:admin#
31-19 no debug address_binding
Description
This command is used to stop the IMPB debug starting when the IMPB module receives an
ARP/IP packet or a DHCP packet.
Format
no debug address_binding
Parameters
None.
Restrictions
Only Administrator users can issue this command.