D-Link X-STACK DES-3200 SERIES - Page 519

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
515
Example
To show user information about SSH configuration:
DES-3200-28P:admin#show ssh user authmode
Command: show ssh user authmode
Current Accounts
Username AuthMode HostName HostIP
------------- ------------- ------------ -------------
test Public Key
alpha Host-based alpha-local 172.18.61.180
beta Host-based beta-local 3000::105
Total Entries : 3
DES-3200-28P:admin#
59-7 config ssh server
Description
This command is used to configure the SSH server general information.
Format
config ssh server {maxsession <int 1-8> | contimeout <sec 120-600> | authfail <int 2-20> |
rekey [10min | 30min | 60min | never] | port <tcp_port_number 1-65535>}
Parameters
maxsession - (Optional) Specify SSH server maximum session at the same time, maximum 8
sessions.
<int 1-8> - Enter the maximum session value here. This value must be between 1 and 8.
contimeout - (Optional) Specify SSH server connection time-out, in the unit of second.
<sec 120-600> - Enter the connection time-out value here. This value must be between 120
and 600 seconds.
authfail - (Optional) Specify user maximum fail attempts.
<int 2-20> - Enter the user maximum fail attempts value here. This value must be between 2
and 20.
rekey - (Optional) Specify time to re-generate session key. There are 10 minutes, 30 minutes, 60
minutes and never for the selection, which the never means do NOT re- generate session key
10min - Specify that the re-generate session key time will be 10 minutes.
30min - Specify that the re-generate session key time will be 30 minutes.
60min - Specify that the re-generate session key time will be 60 minutes.
never - Specify that the re-generate session key time will be set to never.
port - (Optional) Specify the TCP port used to communication between SSH client and server.
The default value is 22.
<tcp_port_number 1-65535> - Enter the TCP port number here. This value must be between
1 and 65535.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.