D-Link X-STACK DES-3200 SERIES - Page 556

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
552
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To disable the sending of linkchange traps:
DES-3200-28P:admin#disable snmp linkchange_traps
Command: disable snmp linkchange_traps
Success.
DES-3200-28P:admin#
63-29 config snmp linkchange_traps ports
Description
This command is used to configure the sending of linkchange traps and per port control for
sending of change trap.
Format
config snmp linkchange_traps ports [all | <portlist>] [enable | disable]
Parameters
all - To specify all ports.
<portlist> - To specify a port range.
enable - Enable sending of the link change trap for this port.
disable - Disable sending of the link change trap for this port.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure the sending of linkchange traps:
DES-3200-28P:admin#config snmp linkchange_traps ports 1-4 enable
Command: config snmp linkchange_traps ports 1-4 enable
Success.
DES-3200-28P:admin#