D-Link X-STACK DES-3200 SERIES - Page 557

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
553
63-30 config snmp coldstart_traps
Description
This command is used to configure the trap for coldstart event.
Format
config snmp coldstart_traps [enable | disable]
Parameters
enable - Enable the trap of the coldstart event. The default state is enabled.
disable - Disable the trap of the coldstart event.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure the trap for coldstart event:
DES-3200-28P:admin#config snmp coldstart_traps enable
Command: config snmp coldstart_traps enable
Success.
DES-3200-28P:admin#
63-31 config snmp warmstart_traps
Description
This command is used to configure the trap state for warmstart event.
Format
config snmp warmstart_traps [enable | disable]
Parameters
enable - Enable the trap of the warmstart event. The default state is enabled.
disable - Disable the trap of the warmstart event.
Restrictions
Only Administrator-level users can issue this command.