D-Link X-STACK DES-3200 SERIES - Page 618

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
614
Parameters
<ipaddr> - The IP address of the trusted host.
network - The network address of the trusted network. The form of network address is
xxx.xxx.xxx.xxx/y.
<network_address> - Enter the network address used here.
add - Add interfaces for that trusted host.
delete - Delete interfaces for that trusted host.
snmp - (Optional) Specify trusted host for SNMP.
telnet - (Optional) Specify trusted host for TELENT.
ssh - (Optional) Specify trusted host for SSH.
http - (Optional) Specify trusted host for HTTP.
https - (Optional) Specify trusted host for HTTPs.
ping - (Optional) Specify trusted host for PING.
all – (Optional) Specify trusted host for all application.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the trusted host:
DES-3200-28P:admin#config trusted_host 10.48.74.121 add ssh telnet
Command: config trusted_host 10.48.74.121 add ssh telnet
Success.
DES-3200-28P:admin#
74-4 show trusted_host
Description
This command is used to display a list of trusted hosts entered on the Switch using the create
trusted_host command above.
Format
show trusted_host
Parameters
None.
Restrictions
None.
Example
To display trusted host: