1ñ15
Child restraint installation
Your vehicle has been designed to
accommodate a child restraint on the rear
seat. When using a child restraint, read the
Installation Instructions supplied with the
child restraint and follow the directions for
fitment carefully.
When installing the child restraint, use the
correct anchor bolt. (5/16" bolt)
The anchor bolt must be engaged at least
5 full threads in the anchorage.
If you have any queries regarding the
installation of a child restraint, consult a
Daewoo Dealer.
Anchorage locations
Child restraint anchor fittings have been
installed to coincide with the three rear
seating positions as follows.
CHILD RESTRAINT
Sedan Models:
Anchorages are located at either side and
center of the shelf behind the rear seat.
They are covered with the shelf carpet and
the anchor fitting nuts are welded beneath
the shelf.
Hatchback Models:
Anchorages are located at either side and
center of the lower rear tail member.
ï Infants and small children should
never be transported unless they
are properly restrained. Restraint
systems for infants and small
children should be used. Make sure
that the system you purchase
meets applicable safety standards.
Read and follow all the directions
provided by the manufacturer.
ï A child restraint system should be
placed in the vehicle's rear seat.
ï When the child restraint system is
not in use, remove it or fasten it with
a safety belt so that it will not be
thrown forward in the case of a
sudden stop or accident.
Under all circumstances the anchor
bolt must be engaged at least 5 full
threads in the anchorage.
ï Children could be endangered in a
crash if their child restraints are not
properly secured in the vehicle.
(Continued)
WARNING
To Next Page
Loading...
