3ñ13
To turn the lights on or off, twist the knob
on the end of the combination switch lever.
There are three positions:
"OFF" position
All lights are off.
position
Parking, tail, license plate and instrument
panel lights are illuminated.
position
Headlight (low beam) and all the above
lights are illuminated.
Head lamp warning chime*
The chime sounds to remind you to turn off
the lights if the driver's door is opened with
them switched on, when the ignition switch
is turned to the "B" or the "I" position.
LIGHT SWITCH
Move this lever up or down to the stop
position to engage the turn indicator signals.
The turn indicator signals will cancel after
the turn is completed then the lever
returns to its normal position.
When lane changing, move the switch part
way to first stop. When released, the
switch will spring back to the off position.
TURN SIGNAL SWITCH
The asymmetrical low beam increases
the field of vision on the right-hand side
of the lane.
When driving in countries which drive
on the left, the 15∞ section of the
headlamp lenses must have a black
cover strip applied.
NOTE
turn
To prevent discharging battery, don't
leave the lights on while the engine is
off.
NOTE
right
left
To Next Page
Loading...
