Daewoo Cielo - Procedures; Jack Specification

7ñ3
ï Pry the wheel cover off with the lug
wrench.
ï Loosen the wheel bolt one turn each
with the wheel wrench, but do not
remove any bolt until the wheel has
been raised off the ground.
ï Turn the jackscrew clockwise four
turns and place the jack at the front or
rear jacking location closest to the
wheel you are changing. Place the jack
under the jacking point at the side sill
as shown in illustration.
PROCEDURES
JACK SPECIFICATION
Cantilever
600kg
Lithium
1 (NLGI)
Type
Maximum
working load
Grease type
Grease class
WARNING
ï Use this jack only with cars with
which the jack fits and that are not
heavier than the lifting limit of the
jack.
ï Make sure that the car is braked that
it cannot roll off the jack when it is
lifted.
ï Fix the jack in the correct position
marked or given by the manufacturer
of the vehicle. Never fix it in other
part of the vehicle.
ï Fix the jack in such a way that your
hand is never under the car during
the operation of the jack.
ï When installing the jack for lifting
the car, it should be perpendicular
to the ground.
ï If you wish to go (work) under the car
when it is lifted, please support the
car additionally with other means
(wooden block for example).