EasyManua.ls Logo

Daewoo Cielo - Anti-Theft System; Programming the Code; Wrong Code

Daewoo Cielo
126 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6ñ16
The antenna will automatically
the radio mode is switched
o
retract when the radio mode
off, or cassette mode is swit
POWER ANTENN
Before switching the radio
make sure that there is no
the antenna while it is re
extened.
CAUTION
OPERATING TIPS F
AUDIO SYSTEM
When the ignition switch is pl
position, the audio system can
on by pushing the power bu
If the ignition switch is turned
while the audio system is oper
key is not removed from the ig
the audio system will continu
e
When the key is removed,
system is switched off autom
Thanks to this new RDS function, the alternative frequency
lists of the selected chain of stations is automatically updated
and this ensured that there is always an instant automatic
search of the best RDS stations in all programs of the
particular chain of stations.
NOTE
ANTI-THEFT SYSTEM*
The identification card, stamped with the security code number,
is provided with the vehicle. Keep it in a safe place, not in the
vehicle.
The audio security system activates immediately whenever the
audio is disconnected from the battery. It is protected by a security
code.
To make the audio system operate again, you must enter a four-
figure security code with the preset station buttons.
Programming the code:
1. Connect the audio system to the battery and turn the ignition
switch to the I position. "CODE" is shown in the display.
2. Press the preset button no. 1 until the correct first figure is
shown on the display.
3. Press the preset button no. 2 until the correct second figure
is shown on the display.
4. By the same method, enter the correct third and fourth figures,
using the preset buttons 3 and 4.
5. After entering the correct four-figure security code, press the
"AUT" button (16). "CODE OK" is shown on the display and
the equipment is ready for use.
Wrong code:
If you press the wrong code by mistake, "ERROR 1" is shown on
the display. After this, "CODE" is displayed again. Then repeat the
above proceduce from 2 to 5.
A total of ten coding attempts can be made and then the time
between each new attempt is doubled. If you forget the security
code, consult your Daewoo Dealer.
Untitled-46 10/31/2006, 12:54 PM16

Table of Contents

Related product manuals