4ñ3
1. To open the engine hood, pull the
release knob to unlatch the hood.
2. Pull the hook up and lift the engine
hood.
3. Hold the engine hood open with the
support rod.
4. Before closing the engine hood,
return the support rod to its clip. This
prevents rattles.
5. Lower the engine hood and make
sure it locks into place by pressing
gently on the front of the hood.
Your vehicle has aerodynamic roof drip
mouldings with installation holes for roof
racks. Avoid damaging the roof when
installing the roof racks.
The installation holes are covered by slides:
press and open by moving in the direction
of the arrow.
ROOF RACK
Fit the mounting parts on the concealed
drip moulding.
ENGINE HOOD
ï Before releasing the engine hood
latch, turn off the ignition, remove
the key, place the gearshift lever in
1st or Reverse with manual
transmisssion, in P (PARK) with
automatic transmission, and set
the parking brake fully.
ï If it is necessary to check beneath
the engine hood with engine
running, place the gear selector
lever in N (NEUTRAL) or P (PARK)
and set the parking brake fully.
Unexpected and possible sudden
vehicle movement may occur if
these precautions are not taken.
ï To avoid the possibility of personal
injury, you should always turn off
the ignition and remove the key
before working under the engine
hood unless the particular
procedure specifically requires
other wise. If the procedure
requires you to run the engine
while working under the engine
hood, do not permit any clothing,
such as neckties, handkerchiefs,
near the engine or radiator fan.
They can become entangled in
moving parts and result in
personal injury and damage to the
vehicle.
Also, remove watches, bracelets
and rings.
WARNING
pull
To Next Page
Loading...
