Daewoo Cielo - Page 63

6ñ3
At that position, turn it clockwise to
increase bass tone, counterclock-
wise to decrease bass tone.
3. Balance/Fader control knob
(push button)
ï Balance control
This knob comes out by pushing it
slightly. At that position, turn it clock-
wise to increase the volume of right
speakers and counterclockwise to
increase the volume of left speakers.
ï Fader control
Pull this knob in the balance control
position until the click sound is
heard, At that position, turn it clock-
wise to increase front speaker vol-
ume, and counterclockwise to in-
crease rear speaker volume.
4. AM/FM band selector button
Press this button to select FM1, FM2,
AM1 or AM2 band.
Band changes as follows;
> FM1 > FM2 >
AM1 > AM2
1. On-off/Volume control knob
(push button)
ï Power on-off
Press this knob to switch on the
audio system and press again to
switch off the audio system.
ï Volume control
Turn this knob clockwise to
increase the volume.
Turn this knob counterclockwise to
reduce the volume.
2. Treble/Bass control knob
(push button)
The bass control knob is used to ad-
just the bass(low-frequency) sound
quality.
The treble control knob is used to ad-
just the treble(high-freqency) sound
quality.
ï Treble control
To use the treble control, push on
the knob and allow it to extend. Turn
it clockwise to increase the treble
and counterclockwise to decrease
the treble.
ï Bass control
Pull this knob in the treble contol po-
sition until the click sound is heard.
5. Auto memory button
When this button is pressed for more
than 2 seconds after selecting band,
auto memory store starts and stations
are automatically searched for in in-
creasing frequency from the frequency
currently received station, and stored
into the preset station buttons 1 through
to 6 in sequence. After storing 6 stations,
this function is automatically resets to
preset scan function, so that the preset
stations are tuned in successively for 5
seconds each.
When the desired station is tuned in,
press the corresponding preset station
button in order to release the preset
scan function.
When you use this auto memory func-
tion, the previously memorized sta-
tions are erased.
6. Eject button
Press the button to eject the cassette
tape.
Untitled-46 10/31/2006, 12:54 PM3