5.14 -
Landing Distances
The
following
tables
provide
the
landing distances for several weight
configurations.
General notes and correction factors:
The following information applies to all the tables in this subsection.
Associated conditions:
- Landing gear DN and flaps LDG,
- Maximum breaking without reverse,
- Hard, dry and level runway.
In table headings:
- GR = Ground roll (in feet),
- D
50
= Landing distance over a 50-foot (15-meter) obstacle (in feet).
Corrections:
- In case of wind, apply the following corrections:
. Reduce total distances by 10% every 10 kt of headwind,
. Increase total distances by 30% every 10 kt of tail wind.
- Other runway surfaces:
Landing distances given in the tables are for landing on hard, dry and level
runway. Other runway surfaces require the following correction factors.
Increase distances by:
. 7% on hard grass,
. 10% on short grass,
. 15% on wet runway,
. 25% on high grass,
. 30% on slippery runway.
Pilot's Information Manual
Section 5
Performance
PIM TBM 960 - Edition 0
Rev. 01
Page 5.14.1
PIM - DO NOT USE FOR FLIGHT OPERATIONS
To Next Page
Loading...