10) Remove protective covers.
G. Final operations
1) If removed, install cabin central carpet suited to the intended use.
NOTE
Slide properly the carpet under doorstep.
2) If necessary, remove the baggage compartment partition net and
install the small
or large cargo net – refer to
Paragraph Use of
Cargo Nets in Subsection 7.3. .
3) Make sure the work area is clean and free from debris.
4) Determine weight
and balance – refer to
Paragraph General in
Subsection 6.4. .
2. Conversion of 4-seat accommodation
into 6-seat accommodation – see
Figure 8.9.1, Figure 8.9.2, Figure 8.9.3 and Figure 8.9.4
A. Tools and consumable materials
- Seat protective covers
B.
Preparation
1) Make sure the SOURCE selector is set to OFF and the crash
lever is down.
2) If installed, remove the cargo net.
3) Remove intermediate seats – refer to paragraph
1.D.
4) Remove the deflectors maintained with self-gripping strap.
5) If necessary, remove the cabin central carpet.
C.
Installation of cabinet
NOTE
This operation must be carried out by a service center.
D. Installation of intermediate seats
1) Install intermediate seats – refer to paragraph 1.F.
2) If removed, install the baggage compartment partition net.
3) If removed, install cabin central carpet.
E. Installation of rear seats – see Figure 8.9.1
1) Make sure the work area is clean and free from debris.
2) Clear the carpet from seat area to facilitate moving in rails.
3) Check that knobs maintain locks in up position.
Section 8
Handling, Servicing and Maintenance
Pilot's Information Manual
PIM TBM 960 - Edition 0
Rev. 01
Page 8.9.5
PIM - DO NOT USE FOR FLIGHT OPERATIONS
To Next Page