User's Manual
157
Parameter Description
Alarm-out Port
Click
Setting
to configure the parameters.
●
Local Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
●
Extension Alarm: Enable alarm activation through the
connected alarm box.
●
Wireless Siren: Enable alarm activation through devices
connected by USB gateway or camera gateway.
Post-Alarm
Set a length of time for the Device to delay turning off alarm after
the external alarm is cancelled. The value ranges from 0 seconds to
300 seconds, and the default value is 10 seconds.
Show Message
Select the
Show Message
checkbox to enable a pop-up message in
your local host PC.
Report Alarm
Select the
Report Alarm
checkbox to enable the system to upload
the alarm signal to the network (including alarm center) when an
alarm event occurs.
Send Email
Select the
Send Email
checkbox to enable the system to send an
email notification when an alarm event occurs.
To use this function, make sure the email function is enabled in
Main Menu
>
NETWORK
>
Email
.
Record Channel
Select the channel(s) that you want to record. The selected
channel(s) starts recording after an alarm event occurs.
The recording for local alarm recording and auto recording must
be enabled.
PTZ Linkage
Click
Setting
to display the PTZ page.
Enable PTZ linkage actions, such as selecting the preset that you
want to be called when an alarm event occurs.
Post Record
Set a length of time for the Device to delay turning off recording
after the alarm is cancelled. The value ranges from 10 seconds to
300 seconds, and the default value is 10 seconds.
Tour Select the
Tour
checkbox to enable a tour of the selected channels.
Picture Storage
Select the
Snapshot
checkbox to take a snapshot of the selected
channel.
To use this function, select
Main Menu
>
CAMERA
>
Encode
>
Snapshot
, in the
Type
list, select
Event
.
Sub Screen
Select the checkbox to enable the function. When an alarm event
occurs, the extra screen outputs the settings configured in
Main
Menu
>
DISPLAY
>
Tour Setting
>
Sub Screen.
●
This function is available on select models.
●
To use this function, extra screen shall be enabled.
To Next Page
Loading...
Need help?
General
