Local Configurations 53
After the P2P function is enabled and connected to the Internet, the system will collects
your information for remote access, and the information includes but not limited to
email address, MAC address, and device serial number.
You can start adding the device.
Cell Phone Client: Use your mobile phone to scan the QR code to add the device
into the Cell Phone Client, and then you can start accessing the Device.
Platform: Obtain the Device SN by scanning the QR code. Go to the P2P
management platform and add the Device SN into the platform. Then you can
access and manage the device in the WAN. For details, please refer to the P2P
operation manual.
You can also enter the QR code of Cell Phone Client and Device SN by clicking
on the top right of the interfaces after you have entered the Main Menu.
To use this function, take adding device into Cell Phone Client as an example.
Adding Device into Cell Phone Client
Use your cell phone to scan the QR code under Cell Phone Client to download the Step 1
application.
On your cell phone, open the application, and then tap . Step 2
The menu is displayed. You can start adding the device.
Tap Device Manager. 1)
The Device Manager interface is displayed. See Figure 5-20.
Figure 5-20
Tap on the top right corner. 2)
To Next Page
Loading...
Need help?
General