Parameter Function
Buzzer
Check the box here to enable this function. The buzzer
beeps when an alarm occurs.
Alarm upload
System can upload the alarm signal to the center
(Including alarm center).
Send Email If you enabled this function, System can send out an email
to alert you when an alarm occurs.
Tour
You need to check the box here to enable this function.
System begins 1-wiindow or multiple-window tour display
among the channel(s) you set to record when an alarm
occurs.
PTZ Activation
Here you can set PTZ movement when an alarm occurs.
Such as go to preset X.
Log
Check the box here, system can record local alarm event
log.
4.8.3.4.2 Net Alarm
The network alarm interface is shown as in Figure 4-78.
Network alarm refers to the alarm signal from the network. System does not anti-dither
and sensor type setup. For setup information, please refer to chapter 4.8.3.4.1.
Figure 4-78
4.8.3.4.3 IPC External Alarm
IPC external alarm interface is shown as below. See Figure 4-79. For setup information,
To Next Page
Loading...
Need help?
General
