Tips
Click to delete the corresponding rule.
You can refer to the chapter 3.11.3.2 to set parameters.
3.11.3.2.3 Object protection (Optional)
Note:
The object protection function is valid once your network camera or your DVR
supports this function.
If your purchased DVR supports the object protection function, it supports one analog
channel. It is not for the digital channel.
System generates an alarm when the object missing/abandoned object alarm occurs.
From main menu->Setting->Event-> Intelligence ->Object, the object protection interface
is shown as below. See Figure 3-127.
Figure 3-127
Check the enable box to enable object detect function.
Click Rule setup to draw the rule.
To Next Page
Loading...
