Dahua XVR User Manual

272
 MAC address conflict.
 PC or DVR network card is not good.
16. Burn error /USB back error.
There are following possibilities:
 Burner and DVR are in the same data cable.
 System uses too much CPU resources. Please stop record first and then begin
backup.
 Data amount exceeds backup device capacity. It may result in burner error.
 Backup device is not compatible.
 Backup device is damaged.
17. Keyboard can not control DVR.
There are following possibilities:
 DVR serial port setup is not correct
 Address is not correct
 When there are several switchers, power supply is not enough.
 Transmission distance is too far.
18. Alarm signal can not been disarmed.
There are following possibilities:
 Alarm setup is not correct.
 Alarm output has been open manually.
 Input device error or connection is not correct.
 Some program versions may have this problem. Please upgrade your system.
19. Alarm function is null.
There are following possibilities:
 Alarm setup is not correct.
 Alarm cable connection is not correct.
 Alarm input signal is not correct.
 There are two loops connect to one alarm device.
20. Remote control does not work.
There are following possibilities:
 Remote control address is not correct.
 Distance is too far or control angle is too small.
 Remote control battery power is low.
 Remote control is damaged or DVR front panel is damaged.
21. Record storage period is not enough.
There are following possibilities:

Dahua XVR Specifications

General

Channels	4/8/16
Video Compression	H.265/H.264
Audio Input	Yes
Audio Output	1 channel RCA
Video Output	HDMI/VGA
Recording Resolution	720P
HDD	1 SATA
Network Interface	RJ45
USB Interface	2 USB 2.0
Power Supply	12V DC
Operating Temperature	-10 °C to +55 °C