Now you can go to the remote device interface to add the camera to the corresponding
channel. See Figure 3-10.
For detailed information, please refer to chapter3.11.1.1.
Please note you can not see the following interface if there is no digital channel. You can
go to Main menu->Setting->Camera->Channel type to set IP channel first. Please refer to
chapter 3.11.1.3.5 for detailed setup information.
Figure 3-10
Click Next button, you can go to Encode interface. See Figure 3-11.
For detailed information, please refer to chapter 3.11.1.3.
To Next Page
Loading...
