Danfoss FC 300

[1] Bus Activates Start command via the serial communication port or
fieldbus option.
[2] Logic AND Activates Start command via the fieldbus/serial communication
port, AND additionally via one of the digital inputs.
[3]
*
Logic OR Activates Start command via the fieldbus/serial communication
port OR via one of the digital inputs.
Select control of the frequency converter start function via the
terminals (digital input) and/or via the fieldbus.
NB!
This parameter is active only when par. 8-01
Control Site is set to [0] Digital and
control word
.
8-54 Reversing Select
Option: Function:
[0] Digital input
[1] Bus
[2] Logic AND
[3]
*
Logic OR Select control of the frequency converter reverse function via
the terminals (digital input) and/or via the fieldbus.
Select
Bus [1], to activate the Reverse command via the serial
communication port or fieldbus option.
Select
Logic AND [2] to activate the Reverse command via the
fieldbus/serial communication port, AND additionally via one of
the digital inputs.
Select
Logic OR [3] to activate the Reverse command via the
fieldbus/serial communication port OR via one of the digital in-
puts.
NB!
This parameter is active only when par. 8-01
Con-
trol Site
is set to [0] Digital and control word .
8-55 Set-up Select
Option: Function:
[0] Digital input
[1] Bus Activates the set-up selection via the serial communication port
or fieldbus option.
[2] Logic AND Activates the set-up selection via the fieldbus/serial communi-
cation port, AND additionally via one of the digital inputs.
[3]
*
Logic OR Activate the set-up selection via the fieldbus/serial communica-
tion port OR via one of the digital inputs.
Select control of the frequency converter set-up selection via
the terminals (digital input) and/or via the fieldbus.
FC 300 Programming Guide 2. How to Programme
MG.33.M2.02 - VLT
®
is a registered Danfoss trademark 133
2