Danfoss FC 300

10-30 Array Index
Range: Function:
0
*
[0 - 255]
Read only from LCP. View array parameters. This parameter is valid only when a De-
viceNet fieldbus is installed.
10-31 Store Data Values
Option: Function:
Parameter values changed via DeviceNet are not automatically
stored in non-volatile memory. Use this parameter to activate a
function that stores parameter values in the EEPROM non-vol-
atile memory, so changed parameter values will be retained at
power-down.
[0]
*
Off Deactivates the non-volatile storage function.
[1] Store edit setup Stores all parameter values from the active set-up in the non-
volatile memory. The selection returns to Off [0] when all values
have been stored.
[2] Store all setups store all parameter values for all set-ups in the non-volatile
memory. The selection returns to
Off [0] when all parameter
values have been stored.
10-32 Devicenet Revision
Option: Function:
Major revision
Minor revision View the DeviceNet revision number. This parameter is used for
EDS file creation.
10-33 Store Always
Option: Function:
[0]
*
Off Deactivates non-volatile storage of data.
[1] On Stores parameter data received via DeviceNet in EEPROM non-
volatile memory as default.
10-39 Devicenet F Parameters
Array [1000]
No LCP access
0 *
[0 - 0] This parameter is used to configure the frequency converter via
DeviceNet and build the EDS-file.
2. How to Programme FC 300 Programming Guide
152 MG.33.M2.02 - VLT
®
is a registered Danfoss trademark
2