Danfoss FC 300

0-20 Display Line 1.1 Small
Option: Function:
[1617]
*
Speed [RPM] Select a variable for display in line 1, middle position. The op-
tions are the same as listed for par. 0-2*.
0-21 Display Line 1.2 Small
Option: Function:
[1614]
*
Motor Current [A] Select a variable for display in line 1, middle position. The op-
tions are the same as listed for par. 0-2*.
0-22 Display Line 1.3 Small
Option: Function:
[1610]
*
Power [kW] Select a variable for display in line 1, right position. The options
are the same as listed for par. 0-2*.
0-23 Display Line 2 Large
Option: Function:
[1613]
*
Frequency [Hz] Select a variable for display in line 2. The options are the same
as those listed for par. 0-2*.
0-24 Display Line 3 Large
Option: Function:
Select a variable for display in line 2.
[1502]
*
Counter [kWh]
The options are the same as those listed for par. 0-20
Display
Line 1.1 Small
.
0-25 My Personal Menu
Array [20]
[0 - 9999] Define up to 50 parameters to appear in the Q1 Personal Menu,
accessible via the [Quick Menu] key on the LCP. The parameters
will be displayed in the Q1 Personal Menu in the order they are
programmed into this array parameter. Delete parameters by
setting the value to ‘0000’.
For example, this can be used to provide quick, simple access
to just one or up to 20 parameters which require changing on a
regular basis (e.g. for plant maintenance reasons) or by an OEM
to enable simple commissioning of their equipment.
2. How to Programme FC 300 Programming Guide
36 MG.33.M2.02 - VLT
®
is a registered Danfoss trademark
2