Danfoss VLT AHF 005

CAUTION
Non-authorized removal of required cover, inappropriate
use, incorrect installation, or operation create the risk of
severe injury to persons or damage to material assets.
•
To avoid the risk, only let authorized and
qualied personnel handle the VLT
®
Advanced
Harmonic Filter AHF005/AHF 010.
NOTICE
The lters shown in this design guide are specially
designed and tested for operation with Danfoss
frequency converters, see chapter 1.2.1 Intended Use.
Danfoss takes no responsibility for the use of the lters
with third-party frequency converters.
NOTICE
REPAIR OF FILTER
Only Danfoss authorized, qualied personnel are allowed
to repair the VLT
®
Advanced Harmonic Filter AHF005/
AHF010. See chapter 8 Spare Parts for more details.
NOTICE
Commissioning is only allowed when there is compliance
with the EMC Directive 2014/30/EU.
The lters meet the requirements of the Low Voltage
Directive 2014/35/EU.
NOTICE
Protect the lter from inappropriate loads, particularly
during transport and handling. Components are not
allowed to be bent. Do not alter the distance in between
isolation. Avoid touching electronic components and
contacts.
Introduction
VLT
®
Advanced Harmonic Filter AHF 005/AHF 010
8 Danfoss A/S © 10/2016 All rights reserved. MG80C502
11