Danfoss VLT AutomationDrive User Manual

3.4 Automatic Motor Adaptation
24
3.5 Check Motor Rotation
25
3.6 Check Encoder Rotation
25
3.7 Local-control Test
25
3.8 System Start Up
26
4 User Interface
27
4.1 Local Control Panel
27
4.1.1 LCP Layout 27
4.1.2 Setting LCP Display Values 28
4.1.3 Display Menu Keys 28
4.1.4 Navigation Keys 29
4.1.5 Operation Keys 29
4.2 Back Up and Copying Parameter Settings
29
4.2.1 Uploading Data to the LCP 30
4.2.2 Downloading Data from the LCP 30
4.3 Restoring Default Settings
30
4.3.1 Recommended Initialisation 30
4.3.2 Manual Initialisation 30
5 About Frequency Converter Programming
31
5.1 Introduction
31
5.2 Programming Example
31
5.3 Control Terminal Programming Examples
32
5.4 International/North American Default Parameter Settings
33
5.5 Parameter Menu Structure
35
5.5.1 Main Menu Structure 36
5.6 Remote Programming with MCT 10 Set-up Software
40
6 Application Set-Up Examples
41
6.1 Introduction
41
6.2 Application Examples
41
7 Status Messages
46
7.1 Status Display
46
7.2 Status Message Definitions Table
46
8 Warnings and Alarms
49
8.1 System Monitoring
49
8.2 Warning and Alarm Types
49
8.3 Warning and Alarm Displays
49
8.4 Warning and Alarm Definitions
50
Contents
VLT
®
AutomationDrive Operating
Instructions
2 MG.33.AJ.02 - VLT
®
is a registered Danfoss trademark

Danfoss VLT AutomationDrive Specifications

General

Supply Voltage	3 x 200-240 V ±10% 3 x 380-500 V ±10% 3 x 525-600 V ±10%
Enclosure	IP20
Output Power Range	0.25 kW - 1.5 MW
Communication Protocols	Modbus RTU
Protection Features	Overcurrent, Overvoltage, Undervoltage, Short circuit, Ground fault, Motor overload
Ambient Temperature Range	-10°C to +50°C (14°F to 122°F)