Danfoss vlt FC 102 - Special Features

5.1.25 30-** Special Features
Parameter
number
Parameter description Default value 4-set-up Change
during
operation
Conver-
sion index
Type
30-2* Adv. Start Adjust
30-22 Locked Rotor Detection ExpressionLimit All set-ups TRUE - Uint8
30-23 Locked Rotor Detection Time [s] ExpressionLimit All set-ups TRUE -2 Uint8
30-5* Unit Conguration
30-50 Heat Sink Fan Mode ExpressionLimit 2 set-ups TRUE - uint8
30-8* Compatibility (I)
30-85 Motor Frequency ExpressionLimit All set-ups FALSE -1 Uint32
30-9* Wi LCP
30-90 SSID ExpressionLimit 1 set-up TRUE 0
VisStr[3
2]
30-91 Channel 5 N/A 1 set-up TRUE 0 Uint8
30-92 Password ExpressionLimit 1 set-up TRUE 0
VisStr[4
8]
30-93 Security type [2] WPA_WPA2 1 set-up TRUE - Uint8
30-94 IP address ExpressionLimit 1 set-up TRUE 0
OctStr[
4]
30-95 Submask ExpressionLimit 1 set-up TRUE 0
OctStr[
4]
30-96 Port 5001 N/A 1 set-up TRUE 0 Uint16
30-97 Wi Timeout Action [0] Do Nothing 1 set-up TRUE - Uint8
5.1.26 31-** Pressure Sensor/Bypass Option
Parameter
number
Parameter description Default value 4-set-up Change during
operation
Conver-
sion index
Type
31-2* Conguration
31-20 Pressure/Speed Curve Adjustment [0] None All set-ups TRUE - Uint8
31-21 Below level threshold ExpressionLimit All set-ups TRUE 0 Int16
31-22 Above level threshold ExpressionLimit All set-ups TRUE 0 Int16
31-23 On Delay Time 60 s All set-ups TRUE 0 Uint16
31-24 Reset Delay Time 9999 s All set-ups TRUE 0 Uint16
31-25 Pressure lter time constant 1 s All set-ups TRUE -2 Uint16
31-2* Readouts
31-26 Pressure Sensor 1 -5000 Pa All set-ups TRUE 0 Int16
31-27 Pressure Sensor 2 -5000 Pa All set-ups TRUE 0 Int16
31-28 Pressure Sensor 3 -5000 Pa All set-ups TRUE 0 Int16
31-29 Pressure Sensor 4 -5000 Pa All set-ups TRUE 0 Int16
31-30 Press Sens Cmp State 0 N/A All set-ups TRUE 0 Uint8
31-31 Press Sens toggle 0 N/A All set-ups TRUE 0 VisStr[21]
31-3* Readout Conf.
31-32 Toggled Readout Conguration [1] Enabled All set-ups TRUE - Uint8
31-33 Toggled Readout Text ExpressionLimit All set-ups TRUE 0 VisStr[12]
5.1.27 32-** MCO Basic Settings
Parameter
number
Parameter description Default value 4-set-up Change
during
operation
Conver-
sion index
Type
32-9* Development
32-90 Debug Source [0] Controlcard 2 set-ups TRUE - Uint8
Parameter Lists Programming Guide
M0010001 Danfoss A/S © 10/2019 All rights reserved. 313
5 5