Dascom 1330 - Page 44

Tally Dascom 1330
29
System setup
Valid Settings
Function
Change Pin #2
No, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10,
11, 12, 13, 14, 15, 16, 17, 18,
19, 20, 21, 22, 23, 24
Defines the first broken / worn out pin.
This pin will be substituted by an
adjacent pin in the second pass printing.
No: Not to substitution of the worn out
pin.
Paper Slip Mode
No, Yes
See section 4.7 Slip.
Yes: The printer takes the top and left
margin settings according to the Slip
Profile.
No: The printer takes standard top and
left margins settings.
Power-Saving
OFF, 1min, 2min, 5min, 10min
Defines the idle period before the printer
gets into Save-energy Mode.
OFF: The printer never goes into
Save-energy Mode.
Multipaper
Disable, Standard, Enhance
Disable: The printer ignores the
determination of paper thickness sensor;
it keeps the impact force and the print
speed unchanged.
Standard: The printer increases the
impact force and reduces the print
speed.
Enhance: The printer prints with even
stronger impact force and slower print
speed.
Impact
Normal, Heavy
Normal: The print speed is faster
causing head hot easily and the impact
force is weaker.
Heavy: The print speed is reduced,
resulting better thermal performance and
copy capability.
Graphic Speed
Normal, Fast, Ultra
Selects different graphic print speed.