Dascom 1330 - Restore Factory Default

Tally Dascom 1330
56
4. Every press on “+1” or “-1” shifts the second line to the right or left, respectively, relative
to the top line by 1 fine step. After pressing “+1” twice and then “OK”, the printer
prompts:
52
| | | | | | | | | | | | | | |
| | | | | | | | | | | | | | |
5. Repeat the adjustment till two grid lines align satisfactory as “|”. Press “OK” again. The
printer asks if you want to save the correction:
Save the parameter settings ([LOAD/EJECT] or [ONLINE] = OK, [LF] = Next)?
Yes
6. At this stage, you have the options to save or give up the correction by pressing OK or
Next, respectively. If you respond with OK, an asterisk “*” appends to “Yes” to confirm
saving change. If you intend to give up the correction by pressing Next, the printer
prompts a “No” Then a confirmative response of OK appends an asterisk “*” to the “No”
prompt. The printer then exits the Bi-directional Alignment and proceeds with the next
setup menu.
5.8 Restore Factory Default
The procedures to restore factory default settings;
1. Hold down the【Load/Eject】key while powering on the printer and then release the key
when the Print Head starts to move. After loading paper, the printer prompts the Printer
Settings
Printer Settings
[LF]=Next, [TOP]=Back, [LOAD/EJECT]=OK, [ONLINE]=Exit, [ONLINE]+[LOAD/EJECT]=
Save and restart the printer.
System Setup
2. Press the Next or Back keys to scroll forward or backward the sub-menus till the printer
shows:
Restore Factory Default
Misalignment reduced
Keys act as proxies for designated functions in the
setting dialog.