Dascom 1330 - 5.1 System Setup

Tally Dascom 1330
28
5.1 System Setup
NOTE: The fat printed words are default.
System setup
Valid Settings
Function
Language
English,Deutsch,Poccия,
Italiano,Français,Español,
Türkçe,Portuguese.
Allows user to select one of the following
languages: English, German, Russian,
Italian, French, Spanish and Turkish,
Portuguese.
Emulation
ESC/P2, IBM
Selects the printer emulation. This
should be the same as the host printer
driver.
Auto CR (ESC/P2)
No, Yes
Yes: LF = LF+CR; No: LF = LF
(Applies to ESC/P2 emulation only)
Auto CR(IBM)
No, Yes
Yes: LF = LF+CR; No: LF = LF
(Applies to IBM emulation only)
Auto LF
No, Yes
Yes: CR = CR+LF; No: CR = CR
Print Dir
Bi-Dir, Uni-Dir
Bi-Dir: Graphics and text are printed in
both directions, resulting in faster
printing speed.
Uni-Dir: Graphics and text are printed
from left to right, resulting in higher
precision.
Form Line
Disable,Enabled,Dashed,
NoPrint
Disable: Grids in block graphics are
disjoint, but grids by graphics commands
or slanted grids (block graphics) are not
affected.
Enabled: Vertical grids are continuous in
all line spacing.
Dashed: Horizontal grids are printed in
dotted lines and vertical grids are not
affected.
NoPrint: Grids are not printed. But
nested grids (by graphical commands)
above 2 levels deep are printed.
Zero
0, Ø
0: No-slashed Zero 0.
Ø: Slashed Zero Ø.
Text Quality Mode
LQ, NLQ, Draft
Selects different text print quality.
Change Pin#1:
No, 1, 2, 3, 4, 5, 6, 7, 8, 9,
10, 11, 12, 13, 14, 15, 16,
17, 18, 19, 20, 21, 22, 23,
24
Defines the first broken / worn out pin.
This pin will be substituted by an
adjacent pin in the second pass printing.
No: No substitution.