Restore all settings to factory defaults.
The carriage initializes and the printer beeps
once after restoration.
To customize the margins and tear-off position,
please refer Chapter 6 for details.
[S1] + [S2] +
[S3 ] + [S4]
Alternate blinking of【Speed】and【Online】LED
indicates ready for firmware update from host.
Update process:
Execute the Configuration Tool on your PC.
Then upload the update firmware to the
printer.
During the update process by both methods,
【Speed】and【Online】LEDs blink
alternatively while【Power】and【Front Exit】
LEDs are constantly on.
Completion:
At completion, the carriage initializes and the
【Power】LED blinks with the 【Front Exit】
LED constantly on.
It takes ~20 seconds to complete the whole
process. The printer resets after completion. If
an error occurs repeat the process.
NOTE: Ensure not to turn off the power or
unplug the interface cable during the whole
process. Only trained operators should do
this update; otherwise, incorrect operation
may easily damage the printer.
4.7 Slip --- Printing on and Settings for Customized Form
Printing on a slip/voucher usually requires unique top and/or left margins, namely the “slip-
profile”. The Control Panel operation supports convenient storing and recalling the slip-profile,
as well as activating and deactivating it.
4.7.1 Slip Setup
This printer uses question and answer sessions to setup parameters here and in
Chapter 5. The printer prompts a message or a parameter name. Then follows a
line of assignments of keys for which the user replies to the prompted message or
changes the value of the parameter.
To configure the top and left margins for slip (slip-profile), please do the followings:
1. Power up printer while pressing the 【TOF】 key until the Print Head starts moving, then
let go.
To Next Page
Loading...
