Tally Dascom 1330
60
4. Follow the given prompt to unload the Setup Instruction Page. Load the customized
form to allow the printer to scan the page length. After the measurement, load another
Setup Instruction Page to let the printer print out the measured length.
The measured form length is: 11.0”, approximately equal to 279mm,
accuracy of plus or minus 0.1 inches.
The measured value has been saved. Remeasure ( [LOAD/EJECT]=OK, [ONLINE] =Exit)?
Yes
5. At this stage:
If【Load/Eject】key is pressed, an asterisk “*” is appended to “Yes” and you should
repeat the procedures for form length measurement as mentioned. Or,
If you input “Exit”, the printer saves the measurement value and proceeds with the next
customized setting.
6.2 Customize Cut Sheet TOF
1. After you follow through all the steps in 6.1 or you input “Next” in step 3 in 6.1, the
printer prompts:
Top Margin
2. You may skip to other customized settings by pressing “Next” or “Back”. Once you
press “OK” to continue with customization of cut sheet TOF, the printer prompts:
Press any key to eject current page, load paper in the Fanfold paper path, and then proceed as
follows:
[TOP] = -(1/72) inch, [LF] = +(1/72) inch, [LOAD/EJECT] = OK, [ONLINE] = Exit, [ONLINE] +
[LOAD/EJECT] = Save and restart the printer.
3. Follow the given prompt to unload the Setup Instruction Page. Ensure the lever is at
position. Then press the【Load/Eject】 key to load fanfold paper from tractors. The top
edge of the form initially aligns with the printer’s tear-off blade. You may input +/- 1/72”
to adjust the TOF position. When you get the desirable TOF, press OK or Exit. The
printer prompts the customized TOF value:
The defined position is: 4.2 mm.
Save the parameter settings ([LOAD/EJECT] or [ONLINE]=OK, [LF]=Next)?
Yes
To Next Page
Loading...
