Page 32
— If you choose Static IP, the second line of the LCD panel
shows “IP Address.”
— Work with your network personnel to obtain the IP
address, subnet mask, and gateway address. Enter
these as described next.
— Press the Enter key to choose “IP Address.” The printer
shows the current IP address and a cursor appears
under the first byte of the address. (The address byte
shows 3 digits when it can be changed and the cursor
appears under the right-most digit.)
— Press the Up or Down Arrow key to change the address.
(Press and hold the Up or Down Arrow key to change
the value quickly.)
— When the first byte is correct, press the Enter key to
move to the second byte.
— Repeat for the third and fourth byte of the IP address.
When you press the Enter key after the fourth byte of the
address, “Subnet Mask” appears on the second line of
the LCD panel.
To Next Page
Loading...
Need help?
General
