Page 66
DM-00760 Duplex Error
The duplex mechanism did not reach the correct
position.
Possible Cause 1: A card or object is jammed in or near the duplex unit.
Solution 1: Open the duplex module cover at the back of the printer (1).
Release any cards or objects stuck in the module (2). Make sure that the
duplex mechanism can move freely in the direction shown (3).
Possible Cause 2: The rollers in the duplex mechanism are dirty.
Solution 2: Run a printer cleaning card, and then clean the printer rollers
including the duplex module rollers.
If you cannot fix the problem, contact your service representative for
assistance.
Related Topics:
"Cleaning the printer" on page 39
2
1
3
To Next Page
Loading...
