Page 65
Printer messages
The CP60 Card Printer with the Built-in Ethernet displays messages on the LCD panel.
If the Data Format is set to CP Driver, messages (that match up with printer messages) also appear on the PC in
message boxes. You might see messages on the LCD panel that do not appear on the PC, because the LCD
displays all printer messages while the CP Driver shows the most important message if a group of messages
occurs at the same time. In addition, the CP Driver can display messages that begin in the driver (not the printer)
and those messages do not appear on the LCD panel.
When a message appears on the LCD panel, do the following:
1 Find the message number in this section. Messages are listed in numerical order.
2 Use the cause and solution information to fix the problem.
3 Make sure cards are loaded and the ribbon is in the printer. Close the printer
cover (if it was opened).
4 Resume printing:
— Click a button on the message box on the PC, which might allow you to retry
the card.
— Press the Ready key on the LCD panel to clear the message and cancel printing of the card.
5 If another message is displayed, repeat steps 1 through 4. If not, the printer returns to the ready or busy state.
To Next Page
Loading...
Need help?
General
