ENTER/EXIT PROGRAMMING MODE 2D SYMBOLOGIES
224
GRYPHON™ I GD/GBT/GM4500
Micro PDF417 Set Length 2
This feature specifies one of the bar code lengths for "Micro PDF417 Length Control" on
page 223
. Length 2 is the maximum label length if in Variable Length Mode, or the sec-
ond fixed length if in Fixed Length includes the bar code’s data characters only. Charac-
ters can be set from 0001 to 0366 characters (pad with zeroes) in increments of 01. Any
value greater than 0366 will be considered to be 0366.
See "
Set Length 2" on page 294 for detailed instructions on setting this feature.
Select Micro PDF417 Length 2 Setting
$CMIL2
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
Length 2 i s 0366 Characters
To Next Page
Loading...
Need help?
General
