SETUP
20
GRYPHON™ I GD/GBT/GM4200
REPLACING THE BATTERY PACK
Use the following procedure to change the reader’s battery:
1. With a screwdriver, unscrew the battery cover screw.
2. Carefully remove the battery cable out of its connector and extract the battery
pack from its slot.
NOTE: Before proceeding, read “Battery Safety” on page 2. To ensure max-
imum performance, Datalogic recommends the replacement of the
rechargeable battery pack if you note either of the following conditions:
• battery life drops below approximately 80% of the original life;
• battery charging time increases significantly.