ENTER/EXIT PROGRAMMING MODE RS-232/USB-COM INTERFACES
42
GRYPHON™ I GD/GBT/GM4200
ACK NAK Options
This enables/disables the ability of the scanner to support the RS-232 ACK/NAK proto-
col. When configured, the scanner and/or host sends an “ACK” when it receives data
properly, and sends “NAK” when the data is in error.
Options are:
• Disable
• Enable for label transmission — The scanner expects an ACK/NAK response from
the host when a label is sent.
• Enable for host-command acknowledge — The scanner will respond with ACK/
NAK when the host sends a command.
• Enable for label transmission and host-command acknowledge
ACK/NAK Protocol = Disable ACK/NAK
$CR2AE00
$CR2AE01
ACK/NAK Protocol = Enable for label transmission
ACK/NAK Protocol = Enable for host-command
acknowledge
$CR2AE02
$CR2AE03
ACK/NAK Protocol = Enable for label transmission and
host command acknowledge
To Next Page
Loading...
Need help?
General
