BLUETOOTH PASSKEY OR PIN CODE ENTRY REQUEST
PRODUCT REFERENCE GUIDE
23
Link to Host in SPP Mode
Link Scanner as HID device to a Bluetooth host
Use this procedure to send data to a Bluetooth host using the Bluetooth HID profile.
1. If using a Bluetooth adapter on the host device, install any driver provided with
the adap
ter.
2. Scan the Link to Host in HID mode label below to make the scanner visible to the
hos
t device.
3. Use the Bluetooth manager of the host device
to "Discover new devices" and
select "GBT4200 …". If you receive an error message, it may be necessary to
change the security settings on either the host device or the scanner.
4. On the host device, open the program that is meant to receive the incoming data.
The data transmitted by the scanner will appear in the program as if it was typed using
the
keyboard of the host device.
Link to Host in HID mode
BLUETOOTH PASSKEY OR PIN CODE ENTRY REQUEST
During the pairing process, based on Host and Reader security settings, you may need to
enter a Bluetooth passkey or PIN code.
When requested by the Host, simply enter the displayed code by scanning the corre-
sponding bar codes for alphanumeric entry listed in
Appendix D. Complete by scanning
the End label. To restart the entering of the passkey, read the Restart label.
Passkey END
Passkey Restart
NOTE: The Gryphon I GBT4200 can be set up to authenticate the remote
system when connecting, by entering a Bluetooth passkey or a PIN code. If
you want to set the security level and authentication options suitable for
your application, or when adding new equipment to a system that requires
authentication or uses a custom security PIN, please see the "
Bluetooth
Security Level" on page 206
.
To Next Page
Loading...
Need help?
General
