Datalogic Gryphon I GFS4170 User Manual

Setup
16 Gryphon™ I GFS4170/GFS4150-9
Resetting Product Configuration to Defaults
Restore Custom Defaults
If you aren’t sure what programming options are in your imager, or you’ve changed some
options and want to restore the Custom Default Configuration that may have been saved in the
scanner, scan the Restore Custom Default Configuration barcode below. This will restore the
custom configuration for the currently active interface.
Restore Custom Default Configuration
Custom defaults are based on the interface type. Configure the imager
for the correct interface before scanning this label.
Restore Factory Configuration
If you want to restore the Factory Configuration for your imager, scan the Restore Factory
Configuration barcode below. The label restores the scanner configuration to the factory
settings, including the interface type. The Label ID set is shown in the “Label ID” section on
page 44 of this manual.
Restore Factory Configuration
The programming items listed in the following sections show the factory default settings for
each of the menu commands.

Datalogic Gryphon I GFS4170 Specifications

General

Brand	Datalogic
Model	Gryphon I GFS4170
Category	Barcode Reader
Language	English