ENTER/EXIT PROGRAMMING MODE ACK Character
Product Reference Guide
29
ACK Character
This setting specifies an ASCII character or hex value to be used as the ACK character. ASCII
characters or any hex value from 0 to 0xFF can be selected. See page 235 for more information.
Select ACK Character Setting
DEFAULT
Setting to previously defined characters such as XON, XOFF, or host com-
mands conflicts with normal operation of these characters. 8-bit data is not
reco
gnized when the option
Data Bits
has been set as 7 Data Bits.
NAK Character
This setting specifies an ASCII character or hex value to be used as the NAK character. ASCII
characters or any hex value from 0 to 0xFF can be selected.
Setting to previously defined characters such as XON, XOFF, or host com-
mands conflicts with normal operation of these characters
. 8-bit data is not
recognized when the option
Data Bits
has been set as 7 Data Bits.
See page 236 for more information.
Select NAK Character Setting
DEFAULT
The ACK/NACK Characters must be different and must not contain reserved
characters (see
Appendix E, Reserved Characters
).
To Next Page
Loading...
Need help?
General
