ENTER/EXIT PROGRAMMING MODE Deactivation Event
Product Reference Guide 59
Deactivation Event
Defines the event deactivating the output. See page 255 in “References” for more information
about this feature.
Disable
Timeout
Reading Phase Active
Deactivation Timeout
When Timeout is the selected Deactivation Event, this specifies the maximum duration of the
output pulse.
Set Deactivation Timeout
To configure this feature, scan the ENTER/EXIT PROGRAMMING
MODE barcode above, then the barcode at left followed by the
digits (in hex) from the Alphanumeric characters in
Appendix
D, Keypad
representing your desired character(s). Exit pro-
gramming mode by scanning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort and not
sa
ve the entry string. You can then start again at the beginning.
CANCEL
DEFAULT
To Next Page
Loading...
Need help?
General
