ENTER/EXIT PROGRAMMING MODE Good Read LED Duration
Product Reference Guide
69
Good Read LED Duration
This feature specifies the amount of time that the Good Read LED remains on following a good
read. The good read LED on time can be set within a range of 100 milliseconds to 25,500
milliseconds (0.1 to 25.5 seconds) in 100ms increments.
See page 251 in “References” for detailed instructions an
d examples for setting this feature.
Select Good Read LED Duration Setting
To configure this feature scan the ENTER/EXIT PROGRAMMING
MODE barc
ode above, then the barcode at left, followed by
the digits (in hex) from the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s).
End by scanning the ENTER/EXIT bar
code again.
Make a mistake? Scan the CANCEL barcode to abort and not
sav
e the entry string. You can then start again at the begin-
ning.
CANCEL
DEFAULT
001 = Good Read LED
stays on for 100 ms.
All LED indicators are off during sleep.
To Next Page
Loading...
Need help?
General
