Datalogic Gryphon I GFS4170 User Manual

ENTER/EXIT PROGRAMMING MODE Serial Start Character
Product Reference Guide 73
Serial Start Character
Select Serial Start Characters
To configure this feature scan the ENTER/EXIT PROGRAMMING
MODE barc
ode above, then the barcode at left, followed by
the digits (in hex) from the Alphanumeric characters in
Appendix D, Keypad representing your desired character(s).
End by scanning the ENTER/EXIT bar
code again.
Make a mistake? Scan the CANCEL barcode to abort and not
sav
e the entry string. You can then start again at the begin-
ning.
CANCEL
DEFAULT
0x02 = Serial Start Character is [02 STX]
See page 253 in “References” for more information.
Serial Stop Character
Select Serial Stop Characters
To configure this feature scan the ENTER/EXIT PROGRAMMING
MODE barcode above, then the barcode at left, followed by
the digits (in hex) from the Alphanumeric characters in
Appendix D, Keypad representing your desired character(s).
End by scanning the ENTER/EXIT bar
code again.
Make a mistake? Scan the CANCEL barcode to abort and not
sav
e the entry string. You can then start again at the begin-
ning.
CANCEL
DEFAULT
0x03 = Serial Stop Character is [03 ETX]
See page 253 in “References” for more information.
The Serial Start/Stop Characters must be different and must not contain
reserved characters (see
Appendix E, Reserved Characters )

Datalogic Gryphon I GFS4170 Specifications

General

Brand	Datalogic
Model	Gryphon I GFS4170
Category	Barcode Reader
Language	English